Terex S-60 J, Service And Repair Manual

Page: 41 / 131

December 2019 Service and Repair Manual
Platform Components
Part No. 1285305GT S ® -60 J 29
7 Remove the pin retaining fasteners from the
jib boom and jib boom leveling arms to
platform rotator pivot pins. Do not remove the
pins.
8 Support the jib boom leveling arms.
9 Use a soft metal drift to drive both pins out,
then remove the platform rotator from the
machine.
Bodily injury hazard. The jib
boom leveling arms may fall if
not properly supported.
10 Lower the jib boom leveling arms.
Crushing hazard. The platform
rotator could fall when removed
from the machine if not properly
supported.
Note: When installing the platform rotator fasteners,
torque the fasteners to specifications.
How to Bleed the Platform
Rotator
Note: This procedure will require two people. Do
not start the engine. Use auxiliary power for this
procedure.
1 Move the function enable toggle switch to
either side and activate the platform rotate
toggle switch to the right then the left through
two platform rotation cycles, then hold the
switch to the right position until the platform is
fully rotated to the right.
2 Place a suitable container underneath the
platform rotator.
3 Open the top bleed screw on the rotator, but
do not remove it.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
4 Move the function enable toggle switch to
either side and hold the platform rotate toggle
switch to the left position until the platform is
fully rotated to the left. Continue holding the
toggle switch until air stops coming out of the
bleed screw. Close the bleed screw.
Crushing hazard. Keep clear of
the platform during rotation.