Terex Genie Z-60 DC, Service Manual

Page: 33 / 193

August 2022 Service and Repair Manual
Platform Controls
Part No. 1307785GT Z ® -60 DC • Z ® -60 FE 21
1-3
How to Clear Fault History
There are 1 - 16 fault codes shown in the fault
history menu 1 being the most recent displayed. It
may be necessary to clear the fault history in order
to acquire the most recent fault codes. It is also
good practice to clear fault history after performing
any calibration procedure.
Note: Perform this procedure with the boom in the
stowed position. Refer to Navigation Menus,
Faults Menu .
1 Turn the key switch to platform controls. Do
not start the engine (if equipped).
2 Pull out the red Emergency Stop button to the
on position at both the ground and platform
controls.
3 Do not press down the foot switch.
4 Move and hold the drive enable toggle switch
in the right direction while holding steer in the
right direction.
5 When the display leaves SYSTEM READY
mode, release the drive enable toggle switch
and the steer joystick.
Result: The display will show FAULTS.
6 Momentarily activate the drive enable toggle
switch in the right direction until ACTIVE
FAULTS is shown on the display.
7 Momentarily activate steer in the right
direction until FAULT HISTORY is shown on
the display.
8 Momentarily activate the drive enable toggle
switch in the right direction to activate the
clear fault history function
Result: The display will read ENABLE at the
bottom.
9 Momentarily activate steer in the right
direction to change NO to YES on the display.
10 Momentarily activate the drive enable toggle
switch to except the change.
Result: The alarm will sound indicating the
fault history has been cleared.