Terex Genie Z-60 DC, Service And Repair Manual

Page: 31 / 125

December 2018 Service and Repair Manual
Platform Controls
Part No. 1271125GT Z®-60/37 DC • Z®-60 /37 FE 21
13 Momentarily activate drive enable switch right
to save the value.
Result: The alarm will sound indicating the
setting has been saved. Continue to the next
desired Ramp time adjustment.
Ramp Rate (factory settings)
Primary boom up/down
ramp accelerate (up)
ramp decelerate (down) 2 seconds
0.6 second
Secondary boom up/down
ramp accelerate (up)
ramp decelerate (down) 1.5 second
0.5 second
Turntable rotate
ramp accelerate (up)
ramp decelerate (down) 1.85 seconds
1.25 seconds
Extend/Retract
ramp accelerate (up)
ramp decelerate (down) 2 seconds
0.4 second
Jib up/down
ramp accelerate (up)
ramp decelerate (down) 1 second
0.4 second
Platform rotate
ramp accelerate (up)
ramp decelerate (down) 0.3 second
0.75 second
Propel
ramp accelerate (up)
ramp decelerate (down) 5 seconds
3 seconds
1-2
How to Calibrate Booms Angle
Sensors
Boom angle sensors are installed on the primary
and secondary boom sections. They are used to
detect whether the boom sections are stowed or not
stowed. A two point calibration procedure captures
the signal with the cylinder fully extended and fully
retracted to an angle measurement that is scaled to
degrees within the program. If either angle sensor is
in the uncalibrated state, drive speed is limited to
out-of-stowed speed.
Note: Start this procedure with the boom in a
stowed position. Position the machine in a suitable
location with sufficient vertical space. Refer to
Navigation Menus,
Settings Menu .
1 Pull out the red Emergency Stop button to the
on position at both the ground and platform
controls.
2 Move and hold the drive enable toggle switch
in the right direction while holding steer in the
right direction.
3 When the display leaves SYSTEM READY
mode, release the drive enable toggle switch
and the steer joystick.
Result: The display will show FAULTS.
4 Momentarily activate steer in the right direction
until SETTINGS is shown on the display.
5 Momentarily activate the drive enable toggle
switch in the right direction until you see the
VALVE AND SENSOR SETTINGS screen.
6 Momentarily activate the drive enable toggle
switch in the right direction until you see the
CALIBRATE TILT SENSOR screen.