April 2019
32
GTH-4014 AU, GTH-4018 AU
Part No.
57.0009.0729
First Edition - Fourth Printing
Inspections
45 Press the home button to return to the home
screen.
46 Release the parking brake.
47 Change the position of the transmission control
lever from neutral to reverse. Press and hold
the brake pedal to prevent the telehandler from
driving off.
Result: The LMS screen should automatically
switch to reversing camera view.
48 Using the boom functions joystick, raise the boom
a few centimeters from the ground.
Result: The screen should momentarily switch to
home screen view while the boom is in motion
and then revert to rear camera view when the
boom movement is complete.
Test the Emergency Pump (if equipped)
49 Set the ignition switch to position I.
50 Press the emergency stop push button.
51 Press the Emergency Pump switch for some
seconds.
52 Engage any of the manual levers while pressing
the Emergency Pump switch.
Result: the corresponding movement of the
machine will indicate the Emergency Pump is
working properly.
Test the Seat Switch
53 Sit on the driver seat.
54 Release parking and service brakes.
55 Place transmission into forward or reverse gear.
56 Lift body weight off the driver seat.
57 Push down lightly on the accelerator pedal.
Result:
the machine should not move
.
Test the Outriggers Sensors
58 Lower or raise all the outriggers.
Result:
the load limiting display will accordingly
change the scale of the admissible payloads.