XM158 V1.0-NR
12
Lamp Off if no DMX
With this function you can select to switch off the lamp off automatically if there is no DMX signal). Select
“ON”
by
turning the encoder if you wish to enable this function or
“OFF”
if you don’t.
Lamp on at temp.
With this function you can set the inside temperature from which the projector will restrike the lamp after automatic
lamp shut off.
Lamp off at temp.
With this function you can set the inside temperature at which the projector will automatically switch the lamp off.
Turn the encoder to select the maximum inside temperature between 60° C and 159° C. Inside temperatures below
90° C are not critical. 90° C and more should lead to the lamp being switched off. Please note that the outside
temperature should not exceed 45° C.
When the temperature around the lamp is higher than the preset value continuously up to 5 minutes, the
lamp will be shut off automatically.
If the lamp be shut off automatically due to over heat, it can not be striked again automatically, it must
be turned on again by manually.
PERSONALITY
Status setting
Address via DMX
With this function, you can adjust the desired DMX-address via an external controller.
• Select
“Address via DMX”
by turning the encoder.
• Press the encoder, the display shows “ON” or “OFF”.
• Turn the encoder to select “ON” if you wish to enable this function or “OFF” if you don’t.
• Press the encoder to confirm.
• Press the Mode/Esc-button in order to return to the main menu.
• On the controller, set the DMX-value of channel 1 to "7".
• Set the DMX-value of channel 2 to "7"or "8". When set to "7" you can adjust the starting address between 1 and 255.
When set to "8" you can adjust the starting address between 256 and 511.
• Set the DMX-value of channel 3 to the desired starting address. If you want to set the starting address to 57, set
channel 1 to "7", channel 2 to "7" and channel 3 to "57". If you want to set the starting address to 420,set channel
1 to "7", channel 2 to "8" and channel 3 to "164" (256+164=420).
• Wait for approx. 20 seconds and the unit will carry out a reset. After that, the new starting address is set.
Auto If No DMX
With this function, when the drive is not DMX signal, it runs automatism, close, hold and music, the default is hold.
Pan Reverse
With this function you can reverse the Pan-movement.
Tilt Reverse
With this function you can reverse the Tilt-movement.
Fine resolution
With this function, you can fine resolution switch of pan movement or tilt movement.
Pan Degree
With this function, you can select pan degree for 630 or 540.
Dimmer Speed
With this function, you can select dimmer speed for slow or quick.
Feedback
With this function, you can feedback switch of pan movement or tilt movement.
