Terasic HAN Pilot Platform, Demonstration Manual, Page: 31 / 117

HAN Pilot Platform
Demonstration Manual 30 www.terasic.com
September 6, 2019
demonstration.
1. Insert a SFP+ loopback fixture into the SFP+-A port on the HAN Pilot Platform as shown in
Figure 2-28 .
Figure 2-28 SFP+-A loopback on the HAN Pilot Platform
2. Connect the host PC to the FPGA board using a Mini-USB cable. Please make sure the
USB-Blaster II driver is installed on the host PC.
3. Set MSEL[2:0] to 010.
4. Power on the FPGA Board.
5. Using Quartus to open the quartus project “altera_eth_top.qpf”.
6.
Execute the demo batch file “test.bat” under the batch file folder, alt_eth\demo_batch.
7. Launch the System Console by selecting the menu item “Tools=>System Debugging
Tools=>System Console” in Quartus.
8.
In the Tcl Console pane, type “cd hwtesting/system_console” to change directory to the
folder: ./alt_eth/hwtesting/system_console as shown in
Figure 2-29 .
9.
Type “source gen_conf.tcl” to generates and sends about 4 billion packets as shown in
Figure
2-30 .
10.
Type “source monitor_conf.tcl” to checks the number of good and bad packets received. as