DCH-510P™
User Guide V1.1
18
DVB mode
Multicast IP:
Enter the IP address of the IP stream for the transport stream over IP output.
You can configure the IP stream output mode in Multicast or Unicast.
Multicast
could be established by setting Multicast IP address in the range of
239.255.255.255 to 224.0.0.0.
Unicast
could be established with the same settings of Multicast, the only
differences are the Multicast IP address, and should NOT be in the range of
224.0.0.0 to 239.255.255.255, which is for Multicast. Although the display is
'Multicast IP' on the first row, the stream itself is Unicast. The IP address of
receiver device (maybe PC with XPlayer™) needed to be set to as the unicast
address on DCH-510P™, please don't use DHCP to get a dynamic IP address for
receiver device.
Multicast UDP Port:
Enter the UDP port number of the TS over IP stream output.
IPTV mode
Max Channels (<=32):
you can configure the number of IPTV channel. The valid range goes
from 0 to 32.
After the configuration, you can use
<
> <
>-keys
to roll up and down between the channels. Each
channel should be configured independently.
Channel x: ‘x’
stands for the channel number. Press
<ENTER>-key
to go down to the sub-
menu. There are 4 sub-menus:
x-Multicast IP:
Enter the multicast IP address for the output stream (for the
addresses inside 224.0.0.1 to 239.255.255.255 are belonging to
multicast, for others else are belonging to unicast, the DCH-510P™
will identify it automatically)
x-Multicast Port:
Enter the port number of the output stream.
x-Switch:
Each channel could be switched On/Off independently. The default
value is ‘off’.
x-Program:
it shows all programs carried by the transport stream from the
source selected. Press
<ENTER>-key
and use
<
>
<
>-keys
to
roll up and down between the program names, where a number in
front of the program name indicates the input source:
0-xxxxx:
Displays the program name, which comes from ASI input.
1-xxxxx:
Displays the program name, which comes from TUNER input.
2-xxxxx:
Displays the program name, which comes from TS/IP input
3-xxxxx:
Displays the program name, which comes from the CI.
4-xxxxx:
Displays the program name, which comes from ASI2 input.
5-xxxxx:
Displays the program name, which comes from BISS Decrypted input.
6-xxxxx:
Displays the program name, which comes from MUX TS.
All encrypted programs are labeled with a ‘$’ sign on the first row. Press
<ENTER>-key
to the
program just be selected to be delivered to the specified IPTV channel or to scrap by pressing
<EXIT>-key
.
Summary of Contents for DCH-510P
