6
3.1 Timer
If the timer was not activated, the TOM 584 directly switches on the resistance display in the on-line
operation. In the display appears:
=5.5xE10
Ω
Ω
Ω
Ω
T=OFF
4.
Other Display Information’s
If the maximum measurement is exceeded appears in the display:
>2.0xE12
(T=OFF)
If the minimal measurement becomes under-stride appears in the display:
<2.0xE04
Ω
Ω
Ω
Ω
T=OFF
If the Battery Voltage is lower than 7,6 Volt, report the unit in the change with the current line:
LOW BATTERY !
The accumulator must be charged again, however the current measurement can quietly be completed. If the
Battery Voltage is lower as 7,0 volts, following display appear one after the other. Then the unit
automatically switches off, to avoid a destroying of low Voltage of the battery.
LOW BATTERY
AUTO OFF
SWITCHING OFF
4.1
Display contrast
On the right side of height of the display there is a hole trough it you can screw a potentiometer for adjust
Contrast of the LCD - Display.
5.
PC - Operating
5.1
System requirement
•
PC with 486er CPU or higher
•
3,5” Floppy disk drive 1,44MB (HD)
•
free serial Interface COM1 or COM2
•
Windows98, 2000, XP with EXCEL
5.2
Installations
Put the disk with the TOM software into the floppy drive. Go to „Start“ then Execute. Type Install and press
<Enter>. Now the software will be installed.
