• Fold to center
• Fold those halves
to center
• Roll tightly
• Fold one
side over
Folding Canopy:
• Release handle, crank until slot is
pointing up
• Close handle
• Pass strap underneath and through
the slot (as shown)
• While holding the whole strap
assembly attach both ends
(eg. tent to stake)
• Remove slack, before tightening
• Push ‘release’— lift handle and
tighten ratchet
• Roll-up any excess strap, put under
handle
• Close handle
10
1.) Undo ratchet strap assemblies/untie ropes
2.) Unfasten spring buckle straps, under canopy
3.) Remove leg poles, on one long side
(use tent jacks for larger tents)
4.) Remove adjacent center, leg poles, on short sides
5.) Lower first long side to the ground
6.) Repeat, remove leg poles, on remaining
long side
7.) Lower rest of frame to ground
8.) Lay tarp next to a long side of frame
9.) Loosen canopy corners
10.) Slowly slide canopy off frame—
flapping, in unison, as you go
10.) Fold and bag canopy (dry canopy)
11.) Disassemble poles and connectors
12.) Remove ground stakes
STRIKE PROCEDURE
(basically, reverse order from assembly)
USING RATCHET STRAPS
Release
(push, to lift handle
and to remove strap,
during disassembly)
Handle
Axle/Slot
(Ratchet Buckle Components)
716 832-TENT
(
8368
)
