• Spread tarps (sold separately)
• Unload poles and tent canopy
• Lay canopy over tarp
• Remove slack
• Square the canopy, measure from
corner to corner— measurement should
be the same for second set of corners
• All guy ropes/webs—should be pulled
to the ground, away from canopy
• Lace sections together— start at center
and work outward
• A basic 40ft. tent will have two canopy
sections—with one ‘mid’ section for
every additional 20ft of tent
• Lace the loops and snap the closures,
See (
figure A
)
Special Note:
• For 30,´ 40´ and 60´ wide tents, a two
piece
crown connector
is provided,
to help secure the sections together
• Take it up through the center grommet(s),
then cap it with the nut end
• The center pole would
then get installed
in the connector
STEP 3. LAY OUT TENT
STEP 4. LACING CANOPY
Position tarp and tent in the exact position desired
Lay tarp down first
Mid-section
Center hole
opening and
grommet
Closure
Section 1
Section 2
Closure-ring
Rain Flap
Lace loop
(start)
(outer end)
End-section
End-section
Section seam
Lay tent on top of tarp
Stretch ropes away from canopy
• Starting at Center ridge, push first
loop through corresponding grommet
• Continue lacing the loops, from the
middle out—pull tight at every loop,
as you go
• Snap the closures and close rain flap
as you progress outward
• When you get toward the outer end, lace
the last two or three loops backwards
and tie off the connecting loops
• Last, attach sections using ring and clip
FIGURE A.
2
716 832-TENT
(
8368
)
