background image

• Aluminum side and center poles
• Rope and grommet lace lines
• Ring and snap rain flap closures
• Sealed valances with velcro closures
• Removable ropes (standard on 30´/40´)
• Side and center pole tie ropes
• Sidewall rope (permanently installed)
• Storage bags
• Guy ropes (one per pole— two per 
   corner pole)
• Tent canopy (16 oz., blockout vinyl)
   Canopy-top— in 2 pieces, plus any 
   mid-section extenders
   

See (

appendix A.

)

 

for layout options

(Stake Note: to expedite tent orders we 

include available stakes— this could be 

40˝single or double head option)

Inspect the tent to make sure that 

   there are no holes or tears
• Recommended tools: sledge hammer/ 
   step ladders/ tarp(s)/ tape measure

Note: Tent and Table tents are designed

   for 1/2˝ rope or 2˝ webs and ratchet

• When building or assembling anything 

   above shoulder height, wear a hard hat

• Steel toe boots are recommended

• Inspect the site, look for overhead and

   underground obstructions—such as 

   utilities 

• Call your local utility to have utility 

   lines marked (call 3–5 days ahead)— 

   

call811.com

 is a good resource— 

   ‘click’ 811 in Your State

• Inspect all ropes and tie lines

• Inspect poles, making sure there are 

   no bends or breaks

• Replace or repair any items in poor 

   condition

  

STEP 2. SAFETY CHECK LIST

STEP 1. CHECK ITEM LIST

Center Poles (tent size/

quantity

)

30x40 (1)  / 30x60 (x2)  / 30x80 (x3) / 30x100 (x4)

40x40 (1)  / 40x60 (x2)  / 40x80 (x3) / 40x100 (x4)

Canopy- section example

Guy ropes

Side Poles (tent size/

quantity

)

30x40 (14)  / 30x60 (18)  / 30x80 (22) / 30x100 (x26)

40x40 (16)  / 40x60 (20)  / 40x80 (24) / 40x100 (x28)  

Stakes (tent size/

quantity

)

30x40 (18)  / 30x60 (22)  / 30x80 (26) / 30x100 (30)

40x40 (20)  / 40x60 (24)  / 40x80 (28) / 40x100 (32)

1

716 832-TENT

 (

8368

)

(or)

Summary of Contents for BT-PP48WT4P









Reviews: