9.
If joining more than one unit together, your original unit
should have been assembled with ZTP uprights on one end,
as described in step 4. Simply continue adding shelf supports
and uprights to complete your additional units.
8.
If particle board decking (Ref. No. 6) was ordered, place the
decking on each shelving level. The decking should fit flush
inside the shelf supports. If you have purchased a single unit,
your shelving unit is now complete. For adder units, see step 9.
7.
Shelf deck supports (Ref. No. 5) are necessary for 30”deep units
only. Attach shelf deck supports by inserting the metal prongs
on the deck support into the slots on the shelf supports. 69” x
30” units require two shelf deck supports per level (as shown);
42” x 30” units require only one shelf deck support per level,
place in the center.
6.
Attach the remaining shelf supports at the desired shelf
levels, making sure that all shelf supports are completely
seated in the upright slots.
Holes
55 & 56
NOTE: For archive storage boxes to fit stacked two
high per level, there should be a minimum of 16 holes
between shelf supports. We recommend placing the
bottom shelf support rivet in the 2nd, 19th, 37th, and
55th holes on 84” high units (as shown) and in the 2nd,
20th, and 39th holes on 60” units.
Holes
37 & 38
Holes
19 & 20
Holes
2 & 3
