JACKING UP MACHINE
Use the designated locations to jack up the machine for
service (Figure 84). Empty the recovery and solution
tank and position the machine on a level before jacking.
FOR SAFETY: When servicing machine, jack
machine up at designated locations only. Use jack
or hoist that will support machine weight.
FIG. 84
TRANSPORTING MACHINE
When transporting the machine by trailer or truck, be
certain to follow the transporting procedure below:
1.
Drain machine tanks.
2.
Load the machine using a ramp that can support
the machine weight and person loading it. The
maximum ramp incline should not exceed 11
q
at a
ramp length of 3.7m (12 ft).
3.
Position the front of machine up against the front of
the trailer or truck. Lower the scrub head and
squeegee.
4.
Set the parking brake, if equipped, and place a
block behind each wheel to prevent the machine
from rolling.
5.
Secure with tie--down straps as shown (Figure 85).
It may be necessary to install tie-down brackets to
trailer or truck.
FOR SAFETY: When loading/unloading machine
onto/off truck or trailer, use a ramp that can
support the machine weight and person loading it,
do not exceed a 11
q
ramp incline at a ramp length
of 3.7m (12 ft), use tie--down straps to secure
machine and block machine wheels.
FIG. 85
STORING MACHINE
1.
Charge the batteries before storing machine to
prolong the life of the batteries.
2.
Drain and rinse the tanks thoroughly.
3.
Store the machine in a dry area with the squeegee
and scrub head in the up position.
4.
Open the recovery tank cover to promote air
circulation.
ATTENTION: Do not expose machine to rain, store
indoors.
5.
If storing machine in freezing temperatures, make
sure to drain machine of all water.
For models equipped with the FaST System, follow
the FaST SYSTEM FREEZE PROTECTION
procedure below.
FaST SYSTEM FREEZE PROTECTION
Valve Coupling #1002856 and 15 cm Hose #63182 are
required (Purchased separately).
1.
Remove the FaST--PAK carton and connect the
valve coupling and 15cm hose (purchased parts) to
the supply hose (Figure 86).
FIG. 86
T5 –
Maintenance
(Page 11 of 15)
T5 9002333 REV.0
2
(07-06)
17
M
Summary of Contents for T5
