51
Sentinel 9018513 (12-2018)
OPERATION
EMPTYING THE HOPPER
1. Drive the machine to the debris collection site
or debris container.
2. Press
the
fi
lter shaker button
. The shaker
operates for approximately 30 seconds. Press
the
fi
lter shaker button
again to stop the
fi
lter
shaker.
FOR SAFETY: When using machine, make sure
adequate clearance is available before raising
hopper. Do not raise hopper when machine is
on an incline.
3. Press and hold the
service brake pedal
or set
the
parking brake switch
.
NOTE: The hopper will not lift or tilt unless the
parking brake switch is set or the service brake
pedal is applied.
4. High Dump Machines: Press and hold the
hopper lift button
to raise the hopper to the
desired height.
NOTE: The light in the button remains illuminated
while the button is being pushed and an audible
alarm sounds while the hopper is moving. The rear
camera remains on while the hopper is moving/out
of the home position (raised/tilted).
NOTE: Press the center of the camera image to
turn off the rear camera while the hopper is raising.
NOTE: The hopper will not raise or tilt on an
unsafe incline for raising or tilting the hopper.
An inhibit icon appears when the hopper raise
button or hopper tilt button is pressed when the
front to back incline is more than 20% and the
side to side incline is more than 7%. See INHIBIT
INDICATORS.
RPM
MPH
3
1750
NOTE: The minimum clearance height needed to
high dump the hopper is 5060 mm (199 in).
WARNING: High dump vertical
clearance. Stay clear of overhead
obstructions and power lines.
5. Place
the
directional switch
in the reverse
position, release the brake, and slowly back up
to the debris site or container.
FOR SAFETY: When using machine, use care
when reversing machine. Move machine with
care when hopper is raised.
