IB DM20075 (03- 2019)
11
14. Install the larger diameter end of the brown
eductor into port 1 where the yellow eductor
was previously located in the valve assembly.
(Fig. 51)
FIG. 51
NOTE: The larger diameter end of the brown
eductor fits tighter into port 1 than the smaller
diameter end. Use the larger diameter end for the
tighter fit.
15. Reassemble the lower portion of the valve
assembly onto the valve assembly. Note
position of angled port in relation to the
dispenser handle hub. The valve assembly
must be reassembled as shown. (Fig. 52)
FIG. 52
16. Firmly squeeze the lower portion of the valve
assembly onto the valve assembly. (Fig. 53)
FIG. 53
17. Use hands to attempt to pull the valve
assembly apart. It should not be possible to
pull the valve assembly apart with hands.
18. Reinstall the valve assembly into the
dispenser case. (Fig. 43 / Fig. 44)
19. Reconnect the four solution delivery hoses to
the barbed fittings (eductors) on the valve
assembly. (Fig. 42)
20. Reconnect the bottle fill hose and bucket fill
hose to the dispenser. (Fig. 40 / Fig. 41)
21. Reinstall the cover onto the dispenser.
(Fig. 38 / Fig. 39)
22. Reinstall the selector knob onto the dispenser.
(Fig. 2)
23. Reinstall the dispenser onto the wall.
24. Reconnect the solution supply hose and both
solution lines to the dispenser.
25. Turn on the cold water supply.