Tenmars TM-6002, User Manual

Page: 14 / 22

TM-6002
EN-14
“A.MEMO“ appear to start the Auto-recording function. Press “ “ key
again to disable the Auto-recording function.

Manual data logging mode and Clear data logger memory
1. Press manual data logging key enable manual data logging mode
the display will show increase memory number.
2. Press reading key to view logged readings mode
3. Press up key or down key to scroll through the readings, The LCD
display will show READ. No
：
xxxx indicating memory number and measure
value for internal resistance and voltage
、
time( temperature and DC
current)TM-6002.
4. Press clear key to delete sing data logged reading in the memory.

Auto power off setup
1. Press power: key turn on the meter
,
Press power: key again for 2
seconds to disable auto power off function.
2. Press power: key again for 2 seconds to auto power off setting mode.
3. Press up key or down key change the auto power off time. The
auto power off time default value is 15 minutes.
4. Press enter key store the setup, exit the mode.
6 BATTERY REPLACEMENT
The meter is powered by 1.5V battery x6pcs (NEDA 15F IEC R6 JIS UM-3).
For the battery replacement procedure, please follow the steps below
:

Press power off key to turn the instrument off.

Use a screw driver to unfasten the screws on the battery cover and remove
the cover

Take out the old batteries and replace with new batteries, taking care to
note the correct polarity.

Re-install the battery cover and tighten the holding screws
.
7 External DC Power

External AC to DC adapter: Voltage 9VDC(8~12VDCMax)

Supply current
：＞
1.0ADC

Socket
：
pin Positive, Ground Casing External
WARNING
If the symbol “ ” appears on the LCD, please replace the battery
immediately