Tenker SM9126N, User Manual

Page: 13 / 24

OPERATING THE PRODUCT
- 08 -
@Tenkerofficial support@tenker.co
Connect the pads to the wire by clipping them on, and then remove
the protective film.
Place the pads where the massage sensation is desired, and plug into
one of the ports on the device. For additional relief, repeat the
procedure by putting another two pads on the desired area and plug
into the second port.
Make sure both pads on the skin and not overlapping and make sure
your skin is free from any dirt, oil or lotion.
Turn the device on by sliding the on/off switch at the top of the unit to
the 'on’ position. The unit will be now activated.
Press the "M" button to select a different main mode (there are 6 main
modes to choose from, each main mode contains different
sub-modes). Press the center button to select a different sub-mode
within the current main mode.
Please remember that the strength setting will default to the lowest
setting with each mode selection you make.
Increase the intensity by pressing the + button; decrease the intensity
by pressing the - button.
Press T button, 10,20,30,40,50,60mins timers could be selected.
Default time is 20 minutes.
Turns off the device.
Remove the pads from your skin.
Gently remove the pads from your skin and place them back on the
provided pads holder or protective plastic film.
Gently remove by pulling the corner of the pads. Do not pull the leads.
1.
2.
3.
4.
5.
6.
7.
8.