INSTALLATION INSTRUCTIONS
Gas Furnace: (F/G)MAC
14
440 01 4201 01
Specifications subject to change without notice.
Figure 10
Unconverted Factory Configuration as viewed in the Horizontal Left orientation
If alternate vent position
is required, loosen clamp
on vent elbow inlet.
Remove trap from
collector box.
Remove pressure switch tube
from port on collector box.
Remove relief tube
from relief port on
condensate trap.
Remove middle and right
plug from collector box.
Remove relief tube
from port on collector
box.
Representative drawing only, some models may vary in appearance.
Horizontal Left Trap Configuration
Rotate elbow to
desired position and
torque clamp on inlet
15 lb.-in.
Slide relief tube in
stand-offs to adjust
length.
Attach condensate
trap to collector box
with screw.
Align trap over middle
and right-hand port on
collector box.
Install plugs in open
ports on collector box.
Connect relief tube to
port on collector box.
Trim excess tube.
Route pressure switch tube
underneath relief tube and
connect to port on collector box.
Connect relief tube to
relief port on condensate trap.
A11282
Representative drawing only, some models may vary in appearance.
