29
Temco DV5200 Series
78674
Fuel Conversion
WARNING: This Hi/Lo conversion kit must ONLY be
applied as part of a conversion kit supplied by the
appliance manufacturer for the specific appliance
and type of gas being converted.
The conversion shall be carried out in accordance
with the requirements of the provincial authori-
ties having jurisdiction and in accordance with the
requirements of the CSA B149.2 installation code
(Canada) and with the requirements of the Na-
tional Fuel Gas Code ANSI Z223.1/NFPA 54 (United
States).
WARNING: This conversion kit shall be installed
by a qualified service agency in accordance with
the manufacturer’s instructions and all applicable
codes and requirements of the authority having
jurisdiction. If the information in this instruction is
not followed exactly, a fire, explosion or production
of carbon monoxide may result causing property
damage, personal injury or loss of life. The qualified
service agency is responsible for the proper instal-
lation of this kit. The installation is not proper and
complete until the operation of the converted appli-
ance is checked as specified in the manufacturer’s
instructions supplied with the kit.
Installer Notice: Using an ink pen, fill out the re-
quired information on the conversion label. Remove
the backing from the label and stick the label in a
visible position on the bottom of the fireplace close
to the gas valve.
Installer Notice: These instructions must be left
with the appliance.
Instructions for converting your fireplace from Natural
gas to Propane/LP gas.
All fireplaces are shipped from the factory equipped to
operate on Natural gas. To convert the fireplace to op-
erate on Propane/LP gas, follow the instructions below.
Please see the appropriate parts list for your model for
parts included with the fireplace.
Check the items in the kit with the parts list. Notify the
supplier of any items that are missing before installing
the conversion kit.
T205
Dv burner
fuel conversion
1/8/04 djt
1/8” When Gas Tight
Burner
Orifice
Holding Tabs
T205
Fig. 39
Bend holding tabs down and forward.
T206
Dv burner
bend tabs
1/8/04 djt
Bend Down Tabs
Remove Burner Orifice
T206
Fig. 40
Move burner tube to replace orifice.
1. Turn off the gas supply.
2. Turn off the electrical supply to the appliance if so
equipped.
To Replace Burner Orifice
1. Remove lava rock to expose screws and remove
grate assembly.
2. Use screwdriver and bend holding tabs down and
forward. (Fig. 39 & 40)
T207
air shutter
setting
1/8/04 djt
7/16” (11 mm)
T207
Fig. 41
Air shutter settings for propane/LP gas.
Conversion Parts Inluded with Fireplace
Description
Part Number
Orifice 1.45 mm (Main Burner)-LP
PCOA070H37
Label, Conversion
77740
Pilot, Orifice - LP
76263
Conversion Pressure
Regulator Assy - LP
74655
Label SIT Valve
--
3. Move the burner to the left and off the burner orifice.
(Fig. 40)
4. Using a suitable tool, replace natural orifice #44 with
propane orifice 1.45 mm furnished with conversion
kit. Tighten orifice with suitable tool until gas tight.
(Fig. 39)
5. Move burner back to original position tight to orifice
and bend tabs back up.
6. Set the air shutter opening for the corresponding
gas used. (Fig. 41 and Chart on Page 33)
7. Replace grate assembly.
