Basic (cont.)
RJ-11 Jack Mode
Select a configuration for the Phone jack (J1) and the
Fax jack (J2):
J1 Voice, J2 Voice
to set both jacks for voice calls only
(default setting).
J1 Voice, J2 FAX
to set the phone jack for voice calls
and the fax jack to send and receive fax data.
J1 Voice, J2 Data
to set the phone jack for voice calls
and the fax jack for CSD data calls.
J1 Voice, J2 Auto
to set the phone jack for voice calls
and the fax jack to automatically switch between voice,
fax, and data modes.
One Minute Alert Beep
Select
Enabled
to hear a beep once every minute during
a voice call.
Voice Privacy Tone
Select
Enabled
to hear an alert tone if Voice Privacy
encryption is not available during a voice call.
Call Control
Dialtone after Remote Disconnect
Select
Enabled
to hear a dial tone if a call is terminated
from the other end.
Auto Send Delay
Delay between when you finish dialing and the call is
sent; select from 0 to 10 seconds (3 seconds is default).
Zero Delay Dialing (EOD)
Select
Enabled
to have the SX7T remember numbers
you have dialed at least twice and send calls to those
numbers with no delay when you finish dialing.
Glare Control
Select
Enabled
to enable automatic handling of “call-
collision” (2 calls coming in at the same time).
Dialtone Duration
Length of time a dialtone will remain active when the
receiver is off-hook (10–90 seconds) (40 seconds is
default).
ROH Duration
Length of time the Receiver Off Hook (ROH) tone
will sound after the dialtone duration is complete
(10–90 seconds) (40 seconds is default).
Continuous ROH
Select
Enabled
to allow for continuous ROH tone until
the unit is returned to the on-hook state.
Exit E911 Mode
Click
Exit E911 Mode
button to return the unit to normal
state after an emergency 911 call.
Voice and Fax Options (SX7T Only)
Wi PATH
TM
SX7
20
User Guide
