Phonecell
®
SX5T CDMA
3
User Manual
Connect the SX5 to AC Power
1. A protective earth (safety
ground) terminal (screw)
marked with a protective
earth symbol is provided
on the back of the SX5 -
see Figure 9a
. Connect
this terminal to a good
earth ground (i.e., a cold
water pipe) by means of
an 18 gauge or heavier
insulated wire. The wire
insulation should be
green with a yellow stripe
to indicate that this is a
protective earth (safety
ground) connection.
2. Connect the barrel connector of the power supply to the AC power input receptacle of the
SX5 -
see Figure 9b
.
3. Plug the AC power cord into the power supply.
4. Plug the AC power cord into the AC Power outlet.
HINT:
If there are no batteries in the SX5, it will only power on if the AC/Battery switch is in
the AC position
- see Figure 4
.
5. Check the cellular signal strength and move the unit until you achieve the best signal
possible - see the
LED Status Indicators
section of this manual.
Attach a Telephone to the SX5
1. Plug one end of a standard phone
cord into a phone-
see Figure 10
.
2. Connect the other end of the phone
cord to the telephone port on the side
of the SX5 (marked with a phone icon)
-
see Figure 10
.
Figure 9a –
Earth ground terminal screw.
Protective earth
(safety ground)
terminal screw
Protective earth
symbol
Figure 9b –
Connect the SX5 to AC Power.
AC Power
AC Power Input
AC Power Cord
Power
Supply
Barrel Connector
Figure 10 -
Connect SX5 to Telephone.
