SX4e TDMA 800
•
SX4e Tri-Mode
4
Technical Manual
INSTALLATION
Antenna Location and Setup
The Phonecell SX4e comes with a standard spike antenna
- See Figure 1
. The Phonecell SX4e
comes with a standard spike antenna (TNC). For optimal signal strength, choose an antenna loca-
tion that is above ground and as close to windows (or exterior walls) as possible -
See Figure 2
.
Cellular signal strength is displayed by the Received Signal Strength Indicator (RSSI) LED on the
unit - See the
How to Use the LED Status Indicators
section of this guide.
1) Connect the antenna to the SX4e
- see Figure 1
.
2) Finger-tighten the antenna; do not over-tighten.
Optional Wall-Mount Installation
After you’ve selected a location and made all the necessary connections and adjustments, your
SX4e
is ready for wall-mounting.
1) To mount the Phonecell SX4e on a wall, mark two hole locations 166 mm (6-17/32 inches) apart.
These hole locations match the mounting hooks on the back of the unit
- see Figure 3
.
2) Install the screws (not supplied), leaving a gap (approximately 3mm (1/8 inches)) between screw
head and wall.
3) Mount the FWT onto the screws
- see Figure 4.
Figure 2 - For optimum signal strength, locate the unit
near a window with the antenna pointed upward.
166 mm (6-17/32 inches)
Figure 3 - Mounting hooks for
optional wall mounting.
Figure 4 - Mount the SX4e onto the screws in
the wall.
Standard
Antenna
TNC
Antenna
Connector
Figure 1 - SX4e antenna installation.
