SX4e TDMA 800
•
SX4e Tri-Mode
12
Technical Manual
PHONECELL SX4e USER SETUP
The SX4e can be programmed with an ordinary telephone, which is sometimes referred to as a
POTS (Plain Old Telephone Service) phone.
NOTE
: The User Setup mode is not accessible while you’re in a call.
In the following sections, an
<entered value>
is comprised of the digits
0
through
9
. The digits '
*
'
and '#' are considered invalid when used inside an
<entered value>
, and will cause that com-
mand/value to be rejected.
If there are no key entries within any 2-minute period, the FWT will revert to its normal mode.
Going on-hook (hanging up the phone) will exit the setup mode.
Correct entry of the commands below will be confirmed by the return of the programming tone,
which signifies that the unit is ready to accept the next entry. Incorrect entry will result in a short,
three tone sequence of rising frequencies, followed by the return of the programming tone, which
again signifies that the unit is ready to accept the corrected entry.
How to Enter the User Setup Mode
Use the following access code to enter the User Setup mode:
Press
:
#
*
0
*
1 2 3 4 5 6 7 8 #
The access code is 8 digits. If the access code is not 8 digits or does not match the access code,
the Programming mode cannot be entered. This code is pre-programmed during production and
cannot be changed.
If you enter the access code correctly, the dial tone should change to a different, steady
“Programming” tone and the bottom LED indicator on the front of the Phonecell will blink alternately
RED and GREEN to indicate that you’re in the programming mode.
USER SETUP COMMANDS
In-Call DTMF Signaling Option
Use the following key sequence to set the In-Call DTMF Signaling option:
Press:
#
*
10
*
<In-Call DTMF option> #
The < > brackets represents the 1-digit in-call DTMF signaling option.
Enter
0 for In-Band Signaling;
1 for Out-of-Band Signaling;
2 for both In-Band and Out-of-Band signaling;
3 for neither.
Enter a value between 0 and 3, otherwise the FWT will not update or store this value; the existing
stored parameter will remain. The factory default setting is
1
(Out-of-Band signaling).
Auto SEND Delay
Use the following key sequence to set the Auto SEND Delay
Press
:
#
*
11 #
*
<Auto SEND Delay> #
Enter a value between 2 and 20 seconds, otherwise the Phonecell will not update or store this
value; the existing stored parameter will remain. The factory default setting is
3 seconds.
Pulse Dial Option
Use the following key sequence to set the Pulse Dial option:
Press
:
#
*
12
*
<Pulse Dial option> #
Enter
:
0
to disable pulse dialing capability
1
to enable pulse dialing capability.
Enter either 0 or 1, otherwise the Phonecell will not update or store this value; the existing stored
parameter will remain. The factory default setting is
1
.
