P
HONECELL
SX3e AMPS
17
U
SER
M
ANUAL
Three-Way Conference Calls
- For three-way conference calls, the Out-of-Band
Signaling option must be enabled. Pressing the HOOKFLASH function transmits
the SEND command.
Please see the Data After SEND option below.
Voice Mail
– Out-of-Band Signaling may need to be disabled to interact with
remote voice mail systems to prevent double-pulsing.
See the Data After SEND
option below.
Authentication (A-Key)
– Depending upon your cellular provider, you may be
required to enter an Authentication Code
(A-Key)
before you make or receive any
calls. A-Key is a cellular system solution to prevent cloning, counterfeiting and cel-
lular fraud.
To program the A-Key function, see the Technician Programming
Section – page 25
.
Data After SEND (In-Call Signaling) Option
Depending upon your cellular provider, the Data After SEND option may need to
be
Enabled
or
Disabled
to use special cellular features such as call waiting, three-
way conference calls, voice mail, etc.
Please consult your service provider for the
required Data After Send/In-Call DTMF Signaling configuration.
The Data After SEND option is disabled
(Out-of-Band signaling)
at the factory. To
change the Data After SEND setting, follow the steps below.
How To Set the In-Call DTMF Signaling Option -
Pick up the handset and
listen for dial tone. Then, enter the User-Programming mode by pressing:
#
*
0
*
1 2 3 4 5 6 7 8 #
The dial tone should change to a steady “Programming” tone and the LED
indicator on the front of your Phonecell should blink alternately RED and
GREEN to indicate that you’re now in the Programming mode.
Next, press:
#
*
10
*
<in-call DTMF option> #
The
< >
brackets represents the in-call DTMF signaling option. You must
enter a value between
0
and
3
:
enter
0
for In-Band Signaling;
enter
1
for Out-of-Band Signaling;
enter
2
for both In-Band and Out-of-Band signaling;
enter
3
for neither.
If you enter the option incorrectly, you’ll hear three short beeps followed by
the programming tone. That’s your cue to re-try the steps above. If correct,
you’ll hear the programming tone again. Hang up. Your Phonecell is ready
for use.
Zero Dial Delay for Frequently Called Numbers
A new patent-pending feature enables the Phonecell to recognize your frequently
called phone numbers and send them immediately–without the 3-second Auto
SEND Delay. The Phonecell stores a list of up to 50 numbers in its memory. This
list contains any number that you’ve called at least twice successfully. NOTE:
cycling
(turning ON/OFF)
the power will erase the current list. A new list will be
started when power is re-applied.
To enable or disable this feature, see page 24.
Phonecell Operation – Continued