Teltonika © 2010 All Rights Reserved 9 |
P a g e
Note:
Do not pull out front panel more, than it shown on the picture!
Take out mounting frame and insert SIM card with a contacts face down and “cut-off”
corner on the top.
Note:
Front and back panels are connected with GSM antenna cable! Insure that SIM
card is not PIN protected before it installation.
Attach mounting frame and front panel to its previous position.
2.3.2
Attaching antenna
Screw the antenna in a clockwise direction.
Figure 2.
3G Camera Back Panel
Position the antenna upwards at its connecting joint. This will ensure optimal reception.
2.3.3
Back panel overview
1.
Power supply adapter socket.
2.
Reset Button.
3.
LAN Ethernet Port (RJ45).
4.
A in – Audio Input.
5.
A out – Audio Output.
6.
SD Card – SD Card slot.
7.
ANT - GSM antenna connector.
8.
ALM in – Alarm Input.
9.
ALM out – Alarm Output.
Figure 3.
3G Camera Back Panel View.
2.3.4
6-pin terminal block
The 6-pin terminal block may be used for connecting external alarm sensor or for enabling
infrared light source. Most common used sensor examples are given in section “Typical PIR and door
sensor connection”.
