31
After device is switched on, you have to wait 3 minutes for device to startup. Only then it is
possible to download records. If the memory is fully filled, the records reading may take several
minutes. After reading records, all records are deleted from the device memory. Data records are
stored in a binary file on your PC. You can upload these records from file to TAVL server and
access all the data from TAVL.
TAVL client application lets user to use the following features:
•
Import data file saved from the device to the TAVL;
•
Preview track of the imported data;
•
Generate reports of the imported data.
More details on how to use TAVL application please refer to “TAVL3 application user
manual v1.4” documentation or its later versions.
It can be configured to acquire and send data to server. It will be possible to store up to
3854 data records if GSM is not available at the moment. It will send data later when GPRS is
available again. Note that FM3622 can have memory full of records. In such a case it will start
deleting oldest records in order to save new ones. Sending all the data records to server may
take some time. Sending 3854 records for
FM3622 may take for about 5 hour (exact time may differ depending on GPRS/server load).
5.8
System settings
System settings have 7 configurable parameters:
•
Sleep settings, where user can turn GPS sleep/deep sleep on or off;
•
Analog Input Settings, where user can choose analog input range 10 V or 30 V,
depending on needed accuracy (lower range gives higher accuracy of
measurements), and input voltage;
•
Object Motion Detection Settings, where user can configure 3 ways how FM3622
will detect stopped movement, and change its working mode (for working modes,
read section 5.13)
•
Static navigation settings, where user can turn static navigation on or off;
•
Records Settings, where user can enable or disable records when GPS is not
available (no time synchronization);
•
GNSS Settings, where user can choose satellite system and GNSS FIX Timeout Time
(if after timeout there will not be synchronized time, it will be synchronized via NTP
server).
•
Ignition Source sets ignition triggered functionalities to be triggered by:
o
Power Voltage (if voltage is between High Voltage Level and Low Voltage
Level the ignition is considered to be turned on);
o
Digital Input (DIN1 ON – ignition on, DIN1 OFF – ignition off);
o
Movement (if accelerometer/movement sensor detects movement then
ignition is on, if movement stops – ignition is off).
Downloaded from
www.Manualslib.com
manuals search engine
