Telstra V850a, User Manual

Page: 5 / 23

8 9
Install handset battery
1. Remove the battery compartment cover and align the
two holes in the plug with the socket pins according
to the colour-coded label in the battery compartment,
then snap the plug into place.
2. Place the battery into the compartment.
3. Position the battery compartment cover and slide it
upwards until it clicks into place.
4. Put the handset on the telephone base to charge
the new battery for at least 16 hours. The battery
may have enough charge for short calls. For best
performance, charge for at least 16 hours.
NZWZ]NZOPOWLMPW
You can keep the battery charged by returning the
handset to the telephone base after each use. When the
battery power is fully depleted, a full recharge takes
about 16 hours.
For further information on batteries, please see the
Battery section on page 40.
If the handset will not be used for a long period of time,
remove the battery to prevent possible leakage.
To purchase replacement batteries, please call TecHelp
on 1300 369 193.
Battery Life
After the battery is fully charged for 16 hours, you can
expect the following performance:
Operation Operating time
While in use (talking) Approximately 10 hours
While not in use (idle*) Approximately 100 hours
*Handset is off the telephone base but not in use.
The battery needs charging when:
• A new battery is installed in the handset.
• Battery indicator on screen is flashing.
• The handset does not turn on.
Setting up your Telstra V850a
Desk/table bracket installation
The telephone base comes with a desk/table bracket.
To install the bracket
1. Align the tabs of the bracket with the slots at the
bottom of the telephone base as shown in the
diagram.
2. Slide the bracket towards the centre of the telephone
base until to clicks into place.
To remove the bracket
Push the bracket away from the telephone base as
shown below. Do not remove the bracket by force to
avoid breakage of the tabs.
Setting up your Telstra V850a