2 (5)
Manually add device to network
Start the add mode on the Z-Wave controller. Press the button on the device three times
fast. The device will now be added into the Z-Wave network.
Remove device
Start the exclusion mode on the Z-Wave controller. Press the button on the device three
times fast. The device will now be removed from the Z-Wave network.
Reset the device
Method 1
Remove the device from the Z-Wave network. This will reset the device to factory defaults.
Method 2:
Reset the device by:
Press and hold the button for 5 seconds.
The device will now reset to factory defaults. The LED will now flash slowly, indicating that
it’s no longer added in any Z-Wave network. This procedure is called ‘Device Reset Locally’
and it should only be used when the primary controller is missing or inoperable.
Operating the device
The plug-in switch can be operated by the button on the product or wireless through the
Z-Wave network. A click on the button toggles the switch on or off.
LED-indicator
Please note that the configuration parameter 4, ‘LED Indicator’ might has been set to ‘When
operating plug, the LED is lit for 5 seconds’, making the LED not light up all the time when
the plug status is on.
Not in network
Flashing slowly
On
Steady blue (depending on configuration 4, ‘LED Indicator’)
Off
Off (depending on configuration 4, ‘LED Indicator’)
During interview
Flashing fast
Associations
Association group 1 - Lifeline - Plug status - Max 5 nodes
The plug will send it's status to the node(s) in this group whenever the status of the plug
changes.
Lifeline is normally used to send the plug status to the main controller / gateway.
Telldus is marketed by Proove AB, Sweden
www.proove.se • +46 (0)346 715600
www.telldus.com
