Jupiter SL869 EVK User Guide
1VV0301126 Rev.0 – 2014-01-23
Reproduction forbidden without written authorization from Telit Communications S.p.A. - All Rights Reserved.
Page 19 of 21
Mod. 0810 2011-07 Rev.2
7.3.
Commands Description
The table below summarizes the set of commands for the SL869:
Command ID
Description
$PMTK000
Test packet
$PMTK001
Acknowledge packet
$PMTK010
Output system message
$PMTK101
Hot Restart: Use all available data in the NV Store.
$PMTK102
Warm Restart: Don't use Ephemeris at re-start.
$PMTK103
Cold Restart: Don't use Time, Position, Almanacs and Ephemeris
data at re-start
$PMTK104
Full Cold Restart: It’s essentially a Cold Restart, but additionally
clear system/user (factory status)
$PMTK301
DGPS correction data source mode
$PMTK313
Enable to search a SBAS satellite or not.
$PMTK314
Set NMEA sentence output frequencies.
$PMTK320
Set power saving operation mode.
$PMTK401
API_Query_Dgps_Mode
$PMTK413
API_Query_Sbas_Enabled
$PMTK414
Query current NMEA sentence output frequencies.
$PMTK420
API_Query_Pwr_Sav_Mode Query power saving operation mode.
$PMTK501
DGPS Data Source Mode
$PMTK513
Enable to search a SBAS satellite or not.
$PMTK514
NMEA sentence output frequency setting
$PMTK520
Power saving operation mode
$PMTK604
Query the version information of FW
$PMTK704
Version information of FW.
Unless otherwise noted in the SL869 V2 SW User Guide document, commands are echoed by
the SL869 V2 after the command is executed.
