xN930 M.2 Hardware User Guide
14
Document History
Revision
Date
Changes
0
2013-05-20
First issue
1
2013-07-09
•
Update setting for Pin 21 on the host interface. This
signal is not connected.
•
Updated pin names of pins 1, 21, 69, and 75 in Table 4
and Table 19 to simply reflect HW Configuration use.
•
Updated Table 24 to indicate configuration pins 1, 69,
and 75 are tied to GND.
•
Rename section 3.6 Coexistence Interface to In-Device
Coexistence Interface. Additional information on the Inter-
device coexistence support was added.
•
Updated section 4.1.3 System Trace Tool Section.
•
Updated Figure 5 – RF Engine for WW SKU.
•
Add further information USB LPM to USB section
•
Added information on Seamless Roaming & Wifi Off-
load – SIM_EAP, SIM-AKA under Other Requirements
•
Added information on Antenna Design Guidelines
under Other Requirements.
2
2013-07-29
RF bands updated
3
2013-08-26
Updating on RF bands
Updated section 3.5 and 3.4.5
Updated temp range
4
2013-09-09
HN930-DC product was removed from portfolio
5
2013-09-15
Main & Diversity antenna positions have been swapped.
•
Updated documentation accordingly, Figure 6 and
Figure 10.
•
Updated WWAN M.2 Mechanical drawings, Figure 14
through Figure 17.
•
Updated Card_power_ON_OFF description for
UltraBook in Table 9.
•
Updated comments in Table 15 regarding the
DPR#/SAR signal.
•
Updated SIM DTECTED signal to indicate an external
pull-up.
•
Updated Platform Block Diagrams to show DPR#
signal is connected to an EINT pin (not GPIO) on
XGOLD.
•
Identified Audio Signals on host interface in Table 4.
Previously these were simply defined as Reserved.
•
Updated VBAT requirements in Table 24 and Table
25.
Reproduction forbidden without written authorization from Telit Communications S.p.A. - All Rights Reserved.
Page 76 of 77
