NT910G
User Manual - Telic AG
Pg 12
If these instructions are ignored, Telic AG will not assume responsibility for any damages that are
incurred. Telic AG may refuse warranty claims where evidence of product misuse is found.
Please read the information in this section and the information in Section 6 Installation of the modem
before starting your integration work!
3.1
Audience and Intended Use
This terminal product is targeted towards system integrators who need to add a wireless
communications link to their M2M / IoT application to capture data from the application as well as to
remotely control that application. Any other use is not intended.
3.2
Safety instructions
PLEASE READ THESE SAFETY INSTRUCTIONS AND KEEP A COPY OF THEM.
The NT910 G Terminal contains highly integrated components which can be damaged by electrostatic
discharge if the user would open the housing.
Therefore, only touch the NT910 G Terminal on the housing or connectors and avoid touching
the components on the board.
▪
Always ensure that the use of the modem is permitted. The modem may present a hazard if
used in the proximity of personal medical electronic devices. As a rule, the modem must not
be used in hospitals, airports or planes.
▪
Never use the modem at a gas station, refueling point, blasting area or in any other
environment where explosives may be present.
▪
Operating the modem close to other electronic devices, such as antennas, television sets, and
radios may cause electromagnetic interference.
▪
This product is intended to be used with the antenna or other radiating element at least 20 cm
away from any part of the human body. In applications where this rule cannot be applied, the
application designer is responsible for providing the SAR measurement test report and
declaration.
▪
You are responsible for observing your country's safety standards, and where applicable, the
relevant wiring rules.
Warning
When using products which are exposed to electric voltage the valid regulations have
to be observed.
Always make sure that the device is disconnected from the power supply before opening it.
