Televes 593581, Instruction Manual, Page: 11 / 37

EN
11
3. MPEG
The
H30Evolution
’s MPEG feature will show the
image of the selected service.
3.1. Main window
Below is a capture of a MPEG Info window with a
brief explanation of its features:
Selected channel
Change using
1.2. Setup
Press to change the Channel Info options.
- Ter.Plan: Selects the channel plan
-
Powering
: Selects the preamplifier powering
Press OK button to see
the services list
2.2. Setup
Press to change Spectrum options.
- Ter.Plan: Selects the channel plan
- Powering : Selects the preamplifier powering
- Aim antenna : Emits a modular audible
signal with frequency directly proportional
to signal level in the spectrum trace
according to reference level. It is
recommended to set the reference level
manually, as well as to select the span to
include a frequency range wide enough.
The audible signal becomes continuous when
the signal leves is close to the reference level.
Then it is necessary to increase the reference
level to get a more accurate adjustment.
This is a useful feature to point antennas
without having to look at the display
- Span : 5MHz, 10MHz 20MHz, 50MHz, 100MHz,
200MHz, 500MHz, Full.
Sets the span of the spectrum. To easily change
the span, use the
OK
Button to decrease the
span and the Back Button to increase the span.
- Ref. Level:
Select the reference level of the
spectrum graph
-
dB/div
: 5 dB/div, 10 dB/div
- Tuning : Channel, Frequency
-
A/D
: Auto, Analog, Digital.
- C/N:
ON, OFF. Shows/Hides the C/N measure.
- Hold: ON/OFF. Shows/hides the maximum
graph
- Save datalog : Saves the current spectrum
measurements. You can see the datalogs
using the remote control application.