Televes 554501, User Manual

Page: 11 / 20

EN
11
5) IP out setting
Follow the help guideline for set IP out configuration.
IP Output: The IP Output option, must be enable.
Service IP: The IP Output Port address. The format is xxx.xxx.xxx.xxx (like as
192.168.2.137).
Output IP: The IP Output data receive address. The format is xxx.xxx.xxx.xxx
(like as 224.2.2.2). After set the Output IP address , you must use the new
address to receive IP Output data.
Subnet Mask: General is 255.255.255.0, it is must the same in a local area
network.
Gateway: If the device is in different net segment, you must set the gateway.
Port: The UDP protocol port (like as 8001), you should use Output IP and new
port to receive IP Output data (like as udp://224.2.2.2:8001).
Note : The signal available at the IP Output is the same as the RF output .
The protocol used for the MUX stream is UDP, so to see the modulated
channels you need a program that has this protocol, like VLC Media Player.
In recent versions of this particular program is necessary to put @ before the
IP address, for example, “udp :/ / @ 224.2.2.2:1234”.
Important : Not all computers have the ability to view a service provided by a
554803.
6) Modulator setting
Bandwidth: there are three possible options provided to be selected: 6M, 7M
and 8M.
Constellation: there also have three possible options to be selected: QPSK,
16QAM and 64QAM.
FFT: user can set the FFT (transmission mode) by selecting in the pull-down
menu.
Guard interval: user can select the guard interval value in the pull-down
menu: 1/32, 1/16, 1/8 and 1/4.
FEC: user can select the FEC value in the pull-down menu. There are five
possible options provided to be chosen: 1/2, 2/3, 3/4, 5/6 and 7/8.
RF frequency: the range is 30~1000MHz.
RF output level: the range is -30~-10dBm.
7) Save/Restore
8) Reboot
9) Firmware
This function is used to upgrade the device’s latest software program. If
user wants to update the device to latest version, he should contact with
manufacturer to get the latest version software. When upgrading it, user can
click the “ ” button to select the program needs burned into system.
Note : User should strictly follow the “Warning” information .