23
EN
WHAT IS HAPPENING
POSSIBLE WHY
WHAT TO DO
WHAT TO CHECK/SOLUTIONS
1
The control module LED
is OFF .
Short circuit at
the output of the
antenna control
module. rol de
antena.
Disconnect the coaxial cable
that runs to the antenna control
module.
If now the LED turns ON, it means that there is a short circuit in coaxial cable. Check for any
strand of the braid making short circuit with the inner conductor of the cable on either
connector of end of the cable
If the LED does not turn ON, the problem may be in the power control module, whether the
network adapter or the cigarette lighter adapter (in this case it is assumed that the battery is
in good condition). In either case, replace the damaged item by a new one.
2
The image is not stable,
freezes or pixelate.
You are in an area
in which the level
of the TV signal is
very strong.
Disable the device BOSS-Tech
by pressing the switch on the
antenna control module. The
LED should turn red.
Verify that the image is good and stable.
The level of the
signal at the
output of the
antenna is very
weak.
Check for any obstacle in front
of the antenna.
Remove the obstacle or place the antenna somewhere else.
Verify that the control module
LED is green.
If the LED is not green, press the switch to put it in red (fig. 10).
Check to see if the IEC coaxial
connectors are firmly plugged
into the receptacle.
Make sure that the IEC connector of the coaxial cable is firmly connected.
3
No picture and no sound TV receiveer is
not powered
adequately.
Check that the receiver is
plugged to the mains.
Check the plug on the receiver and check the power cord is not in open circuit or broken.
No le llega señal al
receptor
If the fault is not due to point
1, check that the coaxial cable
connecting the receiver and TV
is not short circuit.
If there is a short in the cable, replaceit by a new one.
Improper
operation of TV
receiver
Check the channel tuning on
the receiver and program them
correctly.
Return a sweep of all the TV channels that are in the area for tune them again.
4
Malfunction, without a
cause that matches the
above
-
-
Consult your dealer or contact a technical specialist.
Troubleshooting
