14. Partially thread the four monitor screws into the
outer threaded holes on the bottom of the monitor.
15. On the monitor plate you will see four keyholes.
Guide the thumb screws in the bottom of the
monitor into these keyholes and slide the monitor
back as far as you can. Tighten the thumbscrews.
Note: Be sure you have your monitor facing the proper
direction. The edge of the monitor with the Telescript
logo is the front of the monitor and should be facing you.
12. Turn the two silver dials on the rear of the backbracket
so the flat side is facing upwards.
13. Lift the beamsplitter frame up until it is in it’s most upright
position and turn the dial until it is tight against the beamsplitter
frame.
