1. Remove the camera heads wedge plate from the cam-
era head and attach to the bottom of the monitor
mounting plate. Depending on the type of camera you
are using, you will need to make sure that you position
this plate in a location that brings the balance of the
system to the center. It may take more than one at-
tempt to get this position correct.
Note: If you are not using a head with your tripod, you can
screw the monitor plate directly to a tripod that has a 3/8
threaded bolt on top.
2. Now attach the monitor plate to the tripod head and
secure it in place.
3. Screw the three camera plate posts into the three
threaded holes in the monitor plate. You can use the hole
in the post to insert a screwdriver through to tighten if
necessary.
4. Remove the three allen bolts from the top of
the posts. Place the camera plate on top of the
posts and align the posts with the corresponding
holes. Make sure the side with the recessed holes
are face up before you insert and tighten the allen
bolts.
