TELES iGATE FCT User’s Guide
18
Previous Page
Table of Contents
Next Page
Restore Factory Default
Use this feature to restore the parameters the unit had
when it was shipped from the factory.
Note:
The PIN code of the channel will be restored to its default
value. The PIN code of the SIM card will not be changed. It is
recommended to change the PIN code of the SIM card to 1234
before this operation or else the channel will start with "wrong PIN
code" status.
1. Ensure that you know the PIN code of the SIM card
and the unit.
2. Dial ** 1343**#. The unit enters the programming
mode and emits the confirmation tone.
3. Dial *5470*#. The unit restores the factory default set-
tings and emits the confirmation tone.
4. Disconnect the unit from the power supply and recon-
nect it.
Set Pulse Drop Signaling Method
If the PABX trunk connected to the unit supports Pulse
Drop, use this command to set the unit to Pulse Drop sig-
nalling mode.
1. Dial ** 1343**#. The unit enters the programming
mode and emits the confirmation tone.
2. Dial *7620*#. The unit emits the confirmation tone.
Set Pulse Drop Width
If Pulse Drop signalling method is used, the width of the
pulse can be controlled using this command. In general—
in order to be recognized by the PABX—the pulse width
must be higher than the parameter used by the PABX.
For example, if the PABX trunk is set to a pulse drop of 1
second then the unit should be set to 1.5 seconds.
By default, the pulse drop width value is 1.5 seconds.
1. Dial ** 1343**#. The unit enters the programming
mode and emits the confirmation tone.
2. Dial *7630*#. The unit emits the confirmation tone.
3. Dial 1 or 2 digits followed by the # sign. The unit sets
the pulse width and emits the confirmation tone.
