TELES iGATE FCT User’s Guide
7
Previous Page
Table of Contents
Next Page
cellular network. You may create several groups,
serving several networks.
c. Determine if the PABX does or does not support
Least Cost Routing (LCR).
•
On PABX's supporting LCR, set the PABX
routing tables to route the calls to the trunk
groups. This is done by selecting the cellular
prefixes to direct the routing. Calls that should
not be made on the iGATE FCT can be
blocked by using the Toll Restriction feature
(see p. 19). The PABX will automatically route
calls to the iGATE FCT.
•
On PABX's that do not support LCR, ensure
users know how to select the right trunk for the
cellular calls (see “Instructions for Users” on
page 9). After making the selection, users will
hear a second dial tone, this one emitted by
the iGATE FCT.
13. Connect the power cable.
14. Continue with the next section, entitled “Initial Start-up
and LEDs”.
Initial Start-up and LEDs
After the power cable is attached, the POWER LED
should be illuminated. If it is not, ensure that the cable is
properly connected to the unit and to the AC mains.
During the first seconds, the STATUS LED blinks. This
indicates that the unit is initializing. Once the SIM card is
registered and operational, the STATUS LED stops
blinking. In certain cases, the LED may continue to blink.
This is normal and reasons appear later in this document.
Verify that the RCPT LVL LED is green. This indicates a
high reception level. (Reception levels are described in
Table 2.) To improve the reception level, move the
antennas to a different location with a better reception
and/or place the antennas on a metal plate no smaller
than 30 x 30cm. If the reception level is still not satisfac-
tory, contact Technical Support.
Table 2: Reception Level Indications
RCPT LED
Reception Level
Green
High reception
-75dBm to - 51dBm
Orange
Medium reception
-87dBm to -77dBm
Red
Low reception
-101dBm to -89dBm
Off
Very low reception or
no reception at all
-113dBm to -103dBm
