Telemotive Engineered XLTX Transmitter Instruction Manual
May 2011
Page 23 of 40
WARNING
THE ACCESS CODES IN THE RECEIVER ARE UNIQUE AND FACTORY PRESET. DO NOT
CHANGE THESE ACCESS CODES UNLESS YOU ARE REPLACING AN EXISTING
RECEIVER AND ITS ACCESS CODE. CHANGING THIS CODE COULD MAKE IT COMMON
WITH ANOTHER RECEIVER ACCESS CODE, WHICH COULD MOVE OTHER EQUIPMENT.
NO TWO SYSTEMS IN ANY LOCATION SHOULD EVER HAVE THE SAME ACCESS CODES
INDEPENDENT OF THE FREQUENCY. FAILURE TO FOLLOW THIS WARNING COULD
RESULT IN SERIOUS INJURY OR DEATH, AND DAMAGE TO EQUIPMENT.
5.3
CONNECTING THE XLTX TO A COMPUTER
The XLTX transmitter contains circuits that permit communication with a computer system via
USB. The USB mini-B plug is located through the IR/USB port window as detailed in Section
3.1.3.
Figure 12: USB mini-B receptacle as viewed through USB/IR port
When plugging in the transmitter to a computer system, the transmitter batteries must be
installed. The USB circuit does not provide power to the transmitter. Magnetek highly
recommends using a fully charged battery pack when using USB and RCP with the transmitter.
