Telemotive Engineered XLTX Transmitter Instruction Manual
May 2011
Page 20 of 40
4.2.3 User
Code
The User Code setting is a unique identifier that allows the user to select multiple modes when
using the same channel. The receiver can be tuned to only ‘hear’ messages sent from a
transmitter with the same user code.
4.2.4 Transmitter
Timeout
This setting controls the amount of time that the transmitter can be inactive before it automatically
shuts off.
The Timeout time can be set from 1 to 60 minutes.
When the unit times out, the transmitter will turn off.
Setting Timeout to 0 disables transmitter timeout.
4.2.5 Backlight
Timeout
Backlight timeout setting controls the amount of time that the backlight will stay on after a
command is pressed before it automatically shuts off.
Backlight Timeout can be set from 1 to 30 seconds.
Setting Time-Out to 0 disables the backlight.
NOTE: Leaving the backlight on longer will decrease the battery run time and will require more
frequent battery replacement (or recharges for optional rechargeable battery packs).
4.2.6 Password
Enable
This setting enables or disables the requirement of entering a password into the transmitter to
enter setup mode.
When the disabled setting is selected the user will go directly into setup mode without being
prompted to enter a password.
Magnetek strongly recommends enabling the setup mode password setting to prevent
unauthorized or accidental changes to parameters.
NOTE: the unit is shipped with the password requirement enabled and utilizing the factory default
password.
WARNING
DO NOT ASSUME THE POWER IS OFF IN THE RECEIVER BECAUSE THE
TRANSMITTER IS TURNED OFF. FAILURE TO FOLLOW THIS WARNING COULD
RESULT IN SERIOUS INJURY OR DEATH AND DAMAGE TO EQUIPMENT.
