Digital Sweep Instruction Manual
OPERATION
telemark.com
41 of 48
Rev 1.0.0
will be stored until the Digital Sweep power is turned off. In
Unlocked
mode the new
location will be stored in permanent memory till it is reset or changed. The Reset button
will reset Latitude and longitude to 0. If the pattern is changed in configuration mode
and the shape exceeds the pocket limit the pattern shift will be reset to 0. Also, any
changes to the pocket limit will reset the pattern shift to 0.
6.4 Run On/Off
1
Figure 6-5, Run On Mode
When in
Run On
mode the pattern that has been selected the Select Pattern menu is
output.
1
Figure 6-6, Run Off Mode
When in
Run
Off
mode the joystick directly controls the e-beam output position,
allowing the user to precondition the material manually. The Joystick lever controls
direction of beam: left [-] & right [+] controls the lateral direction; near [-] (as seen from
the EB source emitter) & far [+] controls the longitudinal direction.
6.5 Remote On/Off
Remote
button toggles between on and off.
Remote On
allows control from a PLC
using the remote-control input on J2 on the back panel. When remote is
on
the operator
can only turn it off, all other operations are disabled.
Remote On
gives full control to the
remote and lights up the Remote LED on the front panel.
