Digital Sweep Instruction Manual
OPERATION
telemark.com
39 of 48
Rev 1.0.0
6 OPERATION
6.1 General Operation
6.1.1 Power-Up
When the front-panel
POWER
switch is turned on, the fans turn on and the LCD lights
and displays the version of the software for 3 seconds then displays the operational
screen shown below.
1
Figure 6-1, Touchscreen Display
Then turn on the power supply HV & Emission. Set the Hi-Voltage at the level
necessary for the material, but set the Emission very low, just enough to barely see a
beam. This way the sweep pattern settings can be judged and finalized without affecting
the material.
6.1.2 Power-Down
When the front-panel
POWER
switch is turned off, all lights and outputs go off. All
patterns are stored in memory; last pattern used will be the current selection when the
unit is turned back on.
