1-5-1
HG2E0DC
CABINET DISASSEMBLY INSTRUCTIONS
1. Disassembly Flowchart
This flowchart indicates the disassembly steps to gain
access to item(s) to be serviced. When reassembling,
follow the steps in reverse order. Bend, route, and
dress the cables as they were originally.
2. Disassembly Method
(1): Identification (location) No. of parts in the figures
(2): Name of the part
(3): Figure Number for reference
(4): Identification of parts to be removed, unhooked,
unlocked, released, unplugged, unclamped, or
desoldered.
P=Spring, L=Locking Tab, S=Screw,
CN=Connector
*=Unhook, Unlock, Release, Unplug, or Desolder
e.g. 2(S-2) = two Screws (S-2),
2(L-2) = two Locking Tabs (L-2)
(5): Refer to “Reference Notes.”
Reference Notes
CAUTION: Locking Tabs (L-1) and (L-2) are fragile.
Be careful not to break them.
1. Remove five Screws (S-2), two Screws (S-3):
TVCR-210(C)
, three Screws (S-3):
TVCR-610(C)
,
and Screw (S-4). Then, slowly lift the VCR Chassis
Unit (Deck Assembly, Jack CBA and Main CBA) up.
2. When reassembling, solder wire jumpers as shown
in Fig. D5.
3. Before installing the Deck Assembly, be sure to
place the pin of LD-SW on Main CBA as shown in
Fig. D6. Then, install the Deck Assembly while
aligning the hole of Cam Gear with the pin of LD-
SW, the shaft of Cam Gear with the hole of LD-SW
as shown in Fig. D6.
ID/
LOC
.No.
PART
REMOVAL
Fig.
No.
REMOVE/*UNHOOK/
UNLOCK/RELEASE/
UNPLUG/DESOLDER
Note
[1]
Top Case
D1
7(S-1)
-
[2]
Front
Assembly
D2
*3(L-1),*4(L-2)
-
[3]
VCR Chassis
Unit
D3-1
D3-2
5(S-2), (S-4),
2(S-3) ---
[ TVCR-210(C) ]
3(S-3) ---
[ TVCR-610(C) ]
1
[4]
Jack CBA
D4
Desolder, (S-5)
-
[5]
Deck
Assembly
D5
D6
2(S-6), Desolder
2,3
[6]
Main CBA
D5
*(L-3) ---
[ TVCR-610(C) ]
-
[7]
Cylinder
Shield
D5
(S-7)
-
[8]
Jack Board
[ TVCR-610(C) ]
D5
----------
-
↓
(1)
↓
(2)
↓
(3)
↓
(4)
↓
(5)
[5] Deck Assembly
[4] Jack CBA
[1] Top Case
[2] Front Assembly
[3] VCR Chassis Unit
[6] Main CBA
[7] Cylinder Shield
[8] Jack Board
[ TVCR-610(C) ]
Fig. D1
(S-1)
(S-1)
(S-1)
[1] Top Case
