Telefunken TTV-149, Owner'S Manual

Page: 3 / 11

Connection of video signal
If you wish to receive video signal from the video player (for example: VCR, VCD or DVD), you must insert the
player’s audio and video output plugs into this TV’s relevant AV input sockets which are two groups in the rear and
front of the TV respectively. As the audio input of the TV is monophonic, be careful not to insert two audio inputs (L
and R) into each group’s two sockets at the same time, and the sockets in the front and the rear can not be used at the
same time. Then press the TV/AV button to get the picture of video signal.
The TV can broadcast the audio and video signals of received programs from the antenna. The output sockets are in
the rear panel (AV-OUT).
Connection of antenna
：
The RF signal received from antenna is received through the RF input socket in the rear panel. In order to get a
good reception, it is necessary to use an outdoor antenna or common antenna TV (CATV) cable .The 75
Ω
coaxial
cable is recommended for eliminating the interference and noise lines resulting from mis-matched impedance .If you
use the 300
Ω
parallel flat cable, please connect with 300
Ω
-75
Ω
adapter according to the following figure.
Battery installation (as shown in figure)
(1) Open the cover.
(2) Put in the batteries. Be sure
that the polarity (+or-)of the
batteries matches that of marks
inside the remote control.
(3) Replace the cover.
If following happens, replace with new
batteries. For example: remote control does
not work normally or cannot control the TV
or is not stable, please replace batteries
according to the figure.
Attention : Exchange weak batteries to
prevent leakage of battery acid into the
remote control. Do not charge, short circuit,
heat or burn normal batteries. Do not use
batteries, such as soda cell and C-Zn cell etc.
( 300Ω )
( 300Ω - 75Ω )
( 75Ω )