Installation of cables
The minimum control cable bend radius is 200 mm. Sharper
bends will increase cable wear rapidly.
Throttle cable
As the throttle cable moves back and forth during opera-
tion, it must not be clamped too close to the mechanism as
this would prevent its motion. Subsequently this would lead
to an overload of the mechanism with stiff shifting and
premature wear as result. Hence, the throttle cable should be
routed with one or two bends close to the mechanism for
troublefree operation. Check that the throttle travel is free by
pushing the shift release knob (F fig. 1 side 2) and moving the
control lever. When correctly installed, the lever can be
moved without noticable resistance or a spongy feeling.
Shift cable
The shifting cable is secured to the mechanism and can
therefore be clamped to a bulkhead adjacent to the
mechanism.
• Guide the mechanism through the hole. Depending
on whether the mechanism is fitted from outside or
inside different techniques are used.
Mounting from inside:
• Shift the mechanism to neutral position with the lever.
• Remove the lever and pull out the mechanism through
the hole. (Fig. 11)
Mounting from outside:
Fit the lever and shift to forward.
Push in the mechanism using the lever, see fig. 12,
and position the mechanism as in fig. 13.
Shift back to neutral position and proceed as per
fig.14 & 15
Mounting the mechanism with attachment plate:
Shift to forward through the entire operation.
Needs least space when mounted from the outside.
Different cutting template is used.
5 (16)
Summary of Contents for B700SS
Page 17: ......
