Teleflex Marine B700SS, Manual

Page: 3 / 17

Using the mechanism
Cable travel must be in accordance with the engine.
Standard feature of the mechanism is pulling throttle
function. This can be changed to pushing throttle function:
• Remove screw and washer (J&K fig. 2). Lift off the
throttle lever (H fig. 2)
• Reposition screw and roller from A to B (fig. 4).
• Turn the throttle lever 180°, and refit. Note that at
pushing throttle the roller (A fig. 5) must be in the
inner groove ( B fig. 5).
The mechanism has a two-sided gear arm suitable
for pulling as well as pushing gear function without prior
modification. The gear cable should be connected to the side
of the lever which gives the correct function. For standard travel
i.e. ± 38 mm connect the gear cable to the outer holes (C fig. 1).
The inner holes (D fig. 1) are intended for special applications
requiring a travel of ± 31 mm.
Trim switch
Fig. 6 describes the trim switch functions and electrical
connection.
lnterlock function
As a safety feature the lever is locked when it reaches neutral
position. Lift the saddle to release.
3 (16)