Teledyne T640, User Manual

Page: 56 / 88

08354B DCN7877 Teledyne API T640 PM Mass Monitor
54
SETUP>INSTRUMENT
As presented in Table 3-1, view product and system information and network
settings, edit network settings, and perform certain maintenance tasks.
Table 3-1. Setup>Instrument Menu
MENU DESCRIPTION
Product Info View Model, Part, and Serial Numbers and Package and Driver
Versions, and options information.
System Info View Windows, RAM, and disk size/space information.
Network Settings View the network settings (configurable through the
Setup>Comm>Network Settings menu, Section 3.2.13).
Date/Time Settings Adjust date, hour, and minutes, select a time zone*, and set the
system clock to either automatically adjust for Daylight Savings
Time or not. (Also see Setup>Vars>Daylight Savings Enable).
*Time Zone change requires a special procedure (Section
3.2.12.2).
NTP Time Settings Configure Network Time Protocol settings for clock adjustments to
synchronize time.
Language Select an available language.
Remote Update When an instrument is connected to a network that is connected to
the Internet, follow the instructions on this Remote Update page to
check for and activate software/firmware updates. (Also see
Section 3.2.6.2).
INSTRUMENT DISPLAY CALIBRATION
(FOR EARLIER INSTRUMENTS)
This section applies to instruments shipped before January 2017. Although
unlikely, if ever the touchscreen appears unresponsive or responds incorrectly, the
screen can be calibrated via the Setup>Instrument>Display Settings menu.
Figure 3-22. Touchscreen Calibration Page
1. Connect a mouse to either of the front panel USB ports.
2. Navigate with the pointer to Setup>Instrument>Display Settings.