Teledyne T200, Operation Manual, Page: 81 / 425

Teledyne API
– T200 NO/NO
2
/NO
X
Analyzer Operation Manual Overview of Operating Modes
79
4.3. SETUP MODE
Use SETUP Mode to configure the analyzer‟s hardware and software features, perform
diagnostic procedures, gather information on the instrument‟s performance and
configure or access data from the internal data acquisition system (DAS). For a visual
representation of the software menu trees, refer to Appendix A.
SETUP Mode is divided between Primary and Secondary Setup menus and can be
protected through password security.
4.3.1. PASSWORD SECURITY
Protect SETUP Mode with a security password through the SETUP>PASS menu
(Section 5.5) to prevent unauthorized or inadvertent configuration adjustments.
4.3.2. PRIMARY SETUP MENU
The areas accessed and configured under the primary SETUP Mode menu are shown in
Table 4-4.
Table 4-4: Primary Setup Mode Features and Functions
MODE OR FEATURE
CONTROL
BUTTON
LABEL
DESCRIPTION
MANUAL
SECTION
Analyzer Configuration
CFG
Lists button hardware and software configuration information. 5.1
Auto Cal Feature ACAL
Used to set up and operate the AutoCal feature.

Only appears if the analyzer has one of the calibration valve
options installed.
5.2, 9.5
Internal Data Acquisition
(DAS)
DAS
Used to set up the DAS system and view recorded data. 7
Analog Output Reporting
Range Configuration
RNGE
Used to configure the output signals generated by the
instruments analog outputs.
5.4
Calibration Password Security
PASS
Turns the calibration password feature ON/OFF. 5.5
Internal Clock Configuration
CLK
Used to set or adjust the instrument’s internal clock. 5.6
Secondary
SETUP
Mode
(Advanced
SETUP
features)
MORE
This button accesses the instruments secondary setup menu.
See
Table 4-5
06858E DCN7057