Teledyne T200, Operation Manual, Page: 82 / 425

Overview of Operating Modes Teledyne API
– T200 NO/NO
2
/NO
X
Analyzer Operation Manual
80
4.3.3. SECONDARY SETUP MENU (SETUP

MORE)
The areas accessed and configured under the secondary SETUP Mode menu are shown
in Table 4-5.
Table 4-5: Secondary Setup Mode Features and Functions
MODE OR FEATURE
CONTROL
BUTTON
LABEL
DESCRIPTION
MANUAL
SECTION
External Communication
Channel Configuration
COMM
Used to set up and operate the analyzer’s various external I/O
channels including RS-232; RS-485, modem communication
and/or Ethernet access.
8
System Status Variables
VARS
Used to view various variables related to the instruments
current operational status.

Changes made to any variable are not acknowledged and
recorded in the instrument’s memory until the
ENTR
button
is pressed.

Pressing the
EXIT
button ignores the new setting.

If the
EXIT
button is pressed before the
ENTR
button, the
analyzer will beep alerting the user that the newly entered
value has been lost.
5.8
System Diagnostic Features
and
Analog Output Configuration
DIAG
Used to access a variety of functions that are used to configure,
test or diagnose problems with a variety of the analyzer’s basic
systems.
Most notably, the menus used to configure the output signals
generated by the instruments’ analog outputs are located here.
5.9, 5.9.2
I
MPORTANT
I
MPACT ON
R
EADINGS OR
D
ATA
Any changes made to a variable during the SETUP procedures are not
acknowledged by the instrument until the ENTR button is pressed. If the EXIT
button is pressed before the ENTR button, the analyzer will make an audible
signal before exiting the menu, alerting the user that the newly entered value had
not been accepted.
06858E DCN7057