Teledyne HPAC-2005, Operation Manual

Page: 38 / 156

38 205356 REV T 3 RU SSPA Chassis Operations Manual
Note
: If detected power falls below lowest detectable threshold it will read
0.00. In reality, RF output power may differ from the displayed value.
Consult the system datasheet on RF detector dynamic range
specifications.
•
Ref.RF
— Indicates system reflected RF power. This value can be dis-
played in dBm or Watts, depending on the RF Unit setting. If the RF pow-
er detector unit is not accessible for any reason, the value shown will be
“N/A”.
Note
: If reflected power falls below lowest detectable threshold it will read
0.00. In reality, RF output power may differ from the displayed value.
Consult the system datasheet on RF detector dynamic range
specifications.
When on this page, pressing the
Enter
key twice will open the Clear Faults Menu. The
Clear Faults Menu is also available from Sys Info Page 1 and N+1 Slave Info Page.
2.2.1.21.1 Clear Faults Menu
This page allows user to clear latched faults conditions, if the Fault Latch option is ena-
bled.
•
1.Clear Faults
— When selected, all latched fault conditions are cleared.
Also Master N+1 unit fault history and SNMP trap history will be cleared
when “Clear Faults” function is selected.
•
2.Back
— When selected, navigates back to System Info page without
clearing fault state holders.
2.2.1.22 N+1 Slave Info Page
Figure 2-8
shows the display for all Slave units in the system.
This page can only be viewed when a SSPA unit is assigned as a N+1 Slave unit. All
normal Info pages pertaining to individual SSPA operation parameters are accessible
on subsequent menu levels. This page becomes the default page for N+1 slave unit.
When on this page, pressing the
Enter
key will open the Clear Faults Menu. The Clear
Faults Menu is also available from Sys Info Page 1 and N+1 Master Page 1.
Figure 2-8: Slave Unit Display